Is there a fuse in a Minn Kota trolling motor?
To be direct, NO. Minn Kota trolling motors do not have internal fuses. However, despite the manufacturer not installing one in the trolling motor, it is a good idea to install a fuse or circuit breaker to protect the internal electronics of the trolling motor.
Why will my trolling motor not turn?
If even a little bit of water found its way inside the motor head, then internal wires, plugs, or circuit breakers may have rusted. If the corrosion is extensive enough, or if essential components of the motor head have rusted through, the props may stop turning.
How do I know if Minn Kota Control Board is bad?
If you have the correct power in, with the trolling motor set to constant, and no power out, the control board is bad.
How do I reset my trolling motor?
Here’s how to reset the motor:
- Press and hold the POWER button until the power is off. …
- Press the POWER button again until the “System Ready” LED light turns on.
- Wait three seconds.
- Press POWER 3 times within a 5 second period.
- Red and Green LED lights will flash and the motor will automatically reset itself.
How do I know if my trolling motor battery is bad?
Repeat ever couple of hours or when you notice a power drop. If one battery drops more than the others, that one is probably bad. If the batteries are being charged fully, start the day at the same voltage and discharge equally, then they are probably all worn out. Just a regular voltmeter.
Does my trolling motor need a fuse?
Coast Guard standards require that any ungrounded conductor be protected by either a fuse or a circuit breaker. … For example, if your trolling motor has a maximum capacity of 38 amps, you’ll need at least a 40- or 50-amp fuse.
Do trolling motors need a circuit breaker?
It is highly recommended that a circuit breaker or fuse be used when installing a trolling motor. … For motors requiring a 60-amp breaker, the Minn Kota MKR-19 60-amp circuit breaker is recommended.