How do you Ohm a 3 phase motor?

How many ohms should a 3 phase motor read?

The reading should be between 0.3 to 2 ohms. If it is 0, there is a short. If it is over 2 ohms or infinite, there is an open. You can also dry the connector and retest to possibly get more accurate results.

How do you know if a 3 phase motor is bad?

Check all three wires singly T1,T2,T3 (all three phases) to the ground wire. Readings should be infinite. If its zero or reads any continuity at all, then a problem exists with either the motor or cable . If it is go directly to the motor and disconnect from cable and check motor and the cable separately.

How many ohms should a motor read?

With a multimeter, measure the resistance between motor frame (body) and earth. A good motor should read less than 0.5 ohms. Any value greater 0.5 ohms indicate trouble with the motor.

How do you find the insulation resistance of a 3 phase motor?

Phase Resistance: Take the insulation tester and set it to 500V. Take each end and place it on different permutations of L1, L2 and L3 and record each reading. Phase to Earth Resistance: Take the insulation tester, using the same setting, and check each lead from phase to the frame of the motor.

IT IS INTERESTING:  What's wrong with my automatic transmission?

How do you calculate the resistance of a 3 phase motor?

R in ohms = Rated voltage /(rated current x1. 732×3. 5). Example : 2000kw motor, rated voltage is 6600v, rated current is 175A, then R= 6600/(175*1.732*3.5) = 6.22.

How do you know if a motor is bad on a multimeter?

With a multimeter set to low ohms (usually 200), test between each winding terminal and the metal casing of the motor. If there is any reading on any of these then the motor is bad, do not use it. You may find that when it runs ungrounded that the casing becomes live at up to supply voltage.