What are the methods of speed control of traction motor?

What are the two types of speed controller?

There are three speed control motor product groups. The “AC speed control motor unit” that uses the most popular single-phase capacitor-run induction motor, the small and highly efficient “Brushless DC motor unit“, and the “Inverter unit” that combines a three-phase induction motor with a small inverter.

What is speed control of motor?

An electric motor is a device that converts electrical energy into mechanical energy. … In a DC shunt motor (the field is in parallel with the armature), the speed is controlled by increasing or decreasing the applied voltage to the shunt field or armature by means of a field rheostat or an armature rheostat.

What is a speed control?

: equipment designed to operate automatically under certain conditions to keep the speed of a railroad train within a predetermined rate.

What are the methods for speed control of separately excited DC motor?

2 Speed control techniques in separately excited dc motor: i) Varying the armature voltage in the constant torque region. ii) In the constant power region, field flux should be reduced to achieve speed above the rated speed.

IT IS INTERESTING:  Does AutoZone replace batteries under warranty?

Which of the following is not the method of speed control of traction motors?

Which of the following is not the method of speed control in DC series motor? Explanation: Diverter means adding a variable resistance in parallel with field winding. Tapped field control is the method where field ampere turns are adjusted in steps by varying the number of turns included in the circuit.

What are the different methods of speed control of single phase induction motor?

Speed control from rotor side:

  • Rotor rheostat control. This method is similar to that of armature rheostat control of DC shunt motor. …
  • Cascade operation. In this method of speed control, two motors are used. …
  • By injecting EMF in rotor circuit.

Which method of speed control is used for DC shunt motor to obtain speed below rated speed?

Armature Resistance Control

Field is directly connected across the supply so flux is not changed due to variation of series resistance. This is applied for DC shunt motor. This method is used in printing press, cranes, hoists where speeds lower than rated is used for a short period only.