Will AutoZone scan my car codes?

Does AutoZone do free OBD scans?

We can help you get a reading yourself. Borrow an OBD reader to get a Check Engine Light reading with the AutoZone Free Fix Finder Service. It’s a simple task that takes less than two minutes.

Does AutoZone scan clear codes?

Did you know that you can get your check engine light scanned for free? Any of the major parts stores in the country, such as: Napa, Advance Auto, Autozone and O’Reilly’s, will scan your vehicle, and tell you the P codes for no charge at all.

Where can I read car codes for free?

If you have a problem with your car and you don’t know what it is, most auto part stores (such as AutoZone, Pep Boys and Advance Auto Parts) will provide a free diagnostic code reading. It is also called an OBD reading.

What code reader does AutoZone use?

AutoZone | Innova’s 3040 OBD II Code Reader.

How long does AutoZone diagnostic take?

If you see a warning light, come to AutoZone

Fix Finder reads information from the Check Engine, ABS, and maintenance lights. The test often takes less than a minute once the reader is plugged in. Find the closest store to you.

IT IS INTERESTING:  What is the lightest toddler car seat?

Is it illegal to clear check engine codes?

It’s called fraudulent concealment and it is illegal. Many states will allow punitive damages. This car dealership should count themselves lucky that you discovered this problem before it caused any personal injuries.

Can AutoZone check readiness monitors?

The Autozone scanner might show this also. There is usually an option for something like Smog Check or something that shows the readiness monitors. Some on my older cars never go to COMPLETE. Some older cars can have 2 NOT READY and pass…

How can I turn off my check engine light to pass emissions?

By the way the easiest way to turn off the check engine light would be to disconnect the battery for 30 seconds. Inorder to pass inspection your car needs to complete a full drive cycle so that all (8) internal monitors have a status of “Ready”.

How can I check my check engine light code without a scanner?

Flip your car’s ignition on and off a couple of times without cranking the engine and finish with the key in the on position. Your car will then check for any saved trouble codes. All the lights on the dash should light up until one remains on—usually the “service engine” light.

Can I drive my car with check engine light on?

If the check engine light comes on while you’re driving, it can be unnerving. Don’t panic, though. … The check engine light means there’s a problem somewhere in your emissions system. Regardless, you’re safe to drive for now as long as the car isn’t performing strangely.

IT IS INTERESTING:  What weight do infant car seats go to?

How can I check car codes?

To read the codes, you will have to plug a scan tool or code reader into the 16-pin OBD II diagnostic connector, which is usually located under the dash near the steering column. The tool will then display the code or codes that have turned on the Check Engine Light. To read codes, you need the proper scan tool.